This brings a dimension arc length of the arc length dimensions CAD AutoCAD2013 Chinese version of the tutorial.
Figure 01
1.] [DIMARC execution command, or select AutoCAD2013 toolbar "mark" - "arc length" button, shown in FIG..
Figure 02
2.AutoCAD2013 command prompt:
Figure 03
In this selected arc segment prompt.
3.AutoCAD2013 command prompt:
Figure 04
If the mouse moves the position of the arc is determined directly marked at the prompt, AutoCAD2013 will be denoted by the actually measured value of the arc length value, shown in FIG..
Figure 05
The above total prompt "multi-line text", same as in the previous linear "text", "angle" of these three options are denoted by the selected operation, will not be described; the following describes the functions of the other two options:
(1) "section (P)":
Figure 06
The section labeled arc length, the implementation of this option, AutoCAD2013 command prompt:
Figure 07
(Arc arc length dimensions specified starting point)
Figure 08
(Specification circular arc length dimension of the end point)
Figure 09
(Mark the location specified arc length, or other options set)
10
(2) "lead (L)":
11
Adding leader object is the arc length dimensions.Only when the arc (or arc segments) is greater than 90 ° This option appears.Is drawn by the radial lead, the center of the arc it points marked.Implementation of this option, AutoCAD2013 command prompt becomes:
12
If at this time go to the top position of the arc length dimension, AutoCAD2013 lead automatically created on a marked size.The prompt use of "no-lead (N)" option, the label can not lead out of the arc length dimension.
13
29 Tutorial Network