Friends who use X1000 series graphics cards must know the mobility in the Vista system The driver has disappeared at the beginning and even the available graphics drivers in the driver download sites on the Internet are very few and the version 7.4 can be used; but the PC desktop computers have been updated to version 9.11 it seems that the current ATI HD It's king X1000 has begun to take a back seat so it's not too much to directly modify the latest PC driver to the mobility driver strategy!
Pre-downloaded resources: The new version of 9.X pure driver catalyst and the corresponding version of CCC (Catalyst Control Center) Msxml (Microsoft XML analyzer) DH mobility modder.net (ATI editor) This is no need to teach it.
The operation method is as follows:
1. Decompress the driver and CCC separately (you don’t need to install it first decompress it to C: ＼ATI＼Support＼9_3_vista32\u0026mdash;\u0026mdash;\u0026mdash;
2 install MSXML install dhmobilitymodder;
3 open and confirm MSXML check 1/ Whether 2/3 is in PASS state define the drive position:
After success click modify OK;
4. Copy the packages/drivers folder in the driver folder to the CCC package folder (if you ask I won’t say much I think everyone Understand) this is the hacking in the title of this article;
5. Just run the setup installation in the CCC folder and finally there will be a report to refer to the installation results;