Transcend JF750 external hard drive mass production repair successful tutorial[Win11 Solutions]

12 2021-08-26 21:20



  Transcend JF750's external hard drive MLC, the speed is not bad, so I want to use it to mass-produce how to recover data from usb and external hard drive the bootable external hard drive, which is the winpe boot disk of cdrom, so that it can be widely how to recover data from usb drive using command prompt compatible with various computers. The boot rate is very high, and the system can be installed at how to recover data from usb flash drive after formatting any time. Repairing a computer or something.

  But mass production always fails. After a long time to how to recover data from usb flash drive for free find the key to mass production success, I will tell you how to do it below.

  Before mass production, how to recover data from usb flash drive not recognized be sure to use the chip to test it. The purpose is to get the main control and flash memory type how to recover data from usb flash drive using cmd and model. As can be seen from the above figure, the main control is SM3267AB, and the flash memory how to recover data from usb that was erased mac is SanDisk's 453A9493 MLC.

  The key to the success of mass production is to select the correct flash how to recover data from wd elements external hard drive memory. We can use the Dialog in the Huirong mass production tool to check the specific model of how to recover data from wd my book external harddrive the flash memory as follows:

  You can see that the specific model of the flash memory is Sandisk how to recover data from wd my cloud hard drive SDTNSGAMA-016G, so we have to check this flash memory in the mass production setting.

  For mass how to recover data from wd passport external hard drive production tools, we choose Huirong MPTOOL V2.5.47 v7, you can use it after downloading it and decompressing how to recover data from western digital external hard drive it.

  So it's OK to do as per the settings in the figure above. The key is that DBF should choose how to recover data off a bad external hard drive your master controller, here SM3267AB, and the flash memory should choose the flash memory model how to recover data off a broken external hard drive we got before, SanDisk···MLC.In downloading isp selection, the same should be selected according to how to recover data off a damaged external hard drive your external hard drive master control and flash memory, that is to say, what kind of flash memory how to recover data off a dead external hard drive or flash memory your external hard drive is, just choose the corresponding one, don't be rigid.

  According how to recover data off a dead phone hard drive to the above settings, the mass production was successful. The setting here is the mass-produced how to recover data off a failed external hard drive cdrom boot disk, so the pre-downloaded winpe image was selected in the production of auto run; how to recover data on a corrupted external hard drive if you just repair the external drive, don't check it. Autorun, only one partition can be reserved in how to recover data on a corrupted internal hard drive the partition setting.

·